Programming of Atmel Smartcards (Funcard, Jupiter1, ... )



Jumper-Settings for MAKInterface Pro:

+--------------------+
| ooooo ::I::;:::: + |
| ooooo II:III::I: - |
+--------------------+


Connect the cable to the left connector of the smartcard contacting unit (article nr. 00505) and connect the free wire to "," like shown on this picture.
With this settings, the MAKInterface Pro is Harpune-compatible


Programming with PonyProg

Select the serial port.

No checkbox selected.

This is the standard setting for Harpune.


Choose Your Atmel CPU (90S2323/43, 90S8515, ...) and continue with the programming.




Also other software, like CardMagic2000, can be used.